Rose N/D gloss emulsion
Product Description
A high quality non-drip gloss plastic emulsion paint based on acrylic emulsion and some inert pigments. It is designed for very good durability of exterior and interior finishes.
Principal Uses
It is reecommended for the interior and exterior surfaces like concretes, plasters, cement rendering,blocks, asbestos, plaster board, wood finishes etc. This product has very good weather resistance and excellent scrub resistance. It is easily washable with water.It provides glossy finish, good color retention and good hiding power. It can be used as top coat over a textured finish.
Technical Data
|
Color |
White or any requested color |
|
Finish |
Glossy |
|
Density (gm/cc) |
1.12 |
|
Volume Solids % |
20% |
|
Theoretical Spreading Rate |
5-6 sq. mt/ lt at 30 micron DFT(depends upon the substrate condition & method of application) |
|
Washability |
Above 2000 cycles |
|
Overcoat Interval |
8 hours |
|
Flash Point |
N/A |
|
Mixing Ratio |
N/A |
|
Pot Life |
N/A |
|
Gallon size |
15 liters |
Storage
The product must be stored in accordance with national regulations.The product must be kept in a
cool and well-ventilated place ,protected from heat and direct sunlight.
Surface Preparation
Should be stable , firm, dry and free from laitance,dust and loose flaking materials,loose old paints, dirt, grease, wax and any other contaminations.
Application Details
|
Range |
Typical |
Maximum |
Minimum |
|
Wet Film Thickness (micron) |
97 |
129 |
97 |
|
Dry Film Thickness (micron) |
30 |
40 |
30 |
|
Temperature |
15oC |
25oC |
40oC |
|
Drying Time (S/D) |
3 hours |
1 hour |
30 minutes |
|
Dry Time (H/D) |
12 hours |
8 hours |
4 hours |
Application Guidelines
|
|
Air spray / Airless spray |
Brush/Roller |
|
Type of Thinner |
Clean water |
Clean water |
|
Volume of Thinner |
0 – 5% 10 – 15% |
5 – 10% |
|
Nozzle Orifice |
0.021 1.5-2.0mm |
- |
|
Nozzle Pressure |
2100 psi 3 – 5 bar |
- |
Paint System Advice
• Apply 1 coat of Rose Masonry Primer ( RS-6498 ) / equivalent primer sealer.
• Water based putty ( RS-6350 ) can be applied and which can be sanded ,cleaned and dried before the application of top coat finishes.
• 1-2 coats of RS-6157 as top coat can be applied over the filler coat or over a
textured coat.
Safety Precaution
• Avoid contact with eyes and prolonged contact with skin.
• Keep containers tightly closed when not in use .
