Rose road mark W/D
Product Description
A quick drying high quality road marking paint based on water based acrylic resin.It is suitable for making lines, marking roads, car parks, play ground and also for high-lighting safety areas such as stairs.
Principal Uses
It is recommended for both interior and exterior surfaces like concrete, masonry, cement rendering, plasters, woods and metals. It provides good adhesion, hiding, quick drying,water resistance and very good scrub resistance.
|
Color |
White or any requested color |
|
Finish |
Matte |
|
Density (gm/cc) |
1.50 |
|
Volume Solids % |
39.7% |
|
Theoretical Spreading Rate |
10 sq. mt/ lt at 40 micron DFT(depends upon the substrate condition & method of application) |
|
Washability |
N/A |
|
Overcoat Interval |
4 hours |
|
Flash Point |
N/A |
|
Mixing Ratio |
N/A |
|
Pot Life |
N/A |
|
Gallon size |
15 liters |
Storage
The product must be stored in accordance with national regulations.The product must be kept in a
cool and well-ventilated place ,protected from heat and direct sunlight.
Surface Preparation
Should be stable , firm, dry and free from laitance,dust and loose flaking materials,loose old paints, dirt, grease, wax and any other contaminations.
Application Details
|
Range |
Typical |
Maximum |
Minimum |
|
Wet Film Thickness (micron) |
103 |
130 |
103 |
|
Dry Film Thickness (micron) |
40 |
50 |
30 |
|
Temperature |
15oC |
25oC |
40oC |
|
Drying Time (S/D) |
2 hours |
1 hour |
30 minutes |
|
Dry Time (H/D) |
8 hours |
4 hours |
2 hours |
Application Guidelines
|
|
Air spray / Airless spray |
Brush/Roller |
|
Type of Thinner |
Clean water |
Clean water |
|
Volume of Thinner |
0 – 5% 10 – 15% |
0 – 10% |
|
Nozzle Orifice |
0.022 1.5-2.0mm |
- |
|
Nozzle Pressure |
2100 psi 3 – 5 bar |
- |
Paint System Advice
• Primer coat not required.
• Filler coat not required.
• 1-2 coats of RS-6799 can be applied over the clean and dry suface.
Safety Precaution
• Avoid contact with eyes and prolonged contact with skin.
• Keep containers tightly closed when not in use .
