Rose emulsion glaze
Product Description
A high quality waterborne clear finish based on pure acrylic resin, used as a protective glaze coat over other Rose waterborne products where a high shine/ gloss in required.
Principal Uses
It is reecommended for the interior and exterior surfaces like concretes , plasters, cement rendering, blocks, asbestos, plaster board, wood finishes etc. This product has very good weather resistance and excellent scrub resistance. It is easily washable with water.It provides glossy finish, good color retention . It can be used as top coat over a textured finish.
Technical Data
|
Color |
Colorless clear |
|
Finish |
Glossy |
|
Density (gm/cc) |
1.03 |
|
Volume Solids % |
24% |
|
Theoretical Spreading Rate |
12 sq. mt/ lt at 20 micron DFT(depends upon the substrate condition & method of application) |
|
Washability |
Above 2000 cycles |
|
Overcoat Interval |
4 hours |
|
Flash Point |
N/A |
|
Mixing Ratio |
N/A |
|
Pot Life |
N/A |
|
Gallon Size |
15 Liters |
Storage
The product must be stored in accordance with national regulations.The product must be kept in a cool and well-ventilated place ,protected from heat and direct sunlight.
Surface Preparation
Should be stable , firm, dry and free from laitance,dust and loose flaking materials,loose old paints, dirt, grease, wax and any other contamination.
Application Details
|
Range |
Typical |
Maximum |
Minimum |
|
Wet Film Thickness (micron) |
83 |
125 |
83 |
|
Dry Film Thickness (micron) |
20 |
30 |
20 |
|
Temperature |
15oC |
25oC |
40oC |
|
Drying Time (S/D) |
3 hours |
2 hour |
30 minutes |
|
Dry Time (H/D) |
8 hours |
4 hours |
2 hours |
Application Guidelines
|
|
Air spray / Airless spray |
Brush/Roller |
|
Type of Thinner |
Clean water |
Clean water |
|
Volume of Thinner |
0 – 5% 10 – 15% |
5 – 10% |
|
Nozzle Orifice |
0.021 1.5-2.0mm |
- |
|
Nozzle Pressure |
2100 psi 3 – 5 bar |
- |
Paint System Advice
• Apply 1 coat of Rose Masonry Primer ( RS-6498 ) / equivalent primer sealer.
• Water based putty ( RS-6350 ) can be applied and which can be sanded ,cleaned and dried before the application of top coat finishes.
• RS-6120 as clear coat can be applied over a textured coat.
Safety Precaution
• Avoid contact with eyes and prolonged contact with skin.
• Keep containers tightly closed when not in use .
