Rose polyurethane gloss
Product Description
A superior quality 2 pack polyurethane high gloss based on polyester polyols and isocyanate resins.
Fractions with polyester polyol is considered as BASE component and fractions with isocyanate is
considered as HARDENER component .
Principal Uses
It is recommended as a top coat mainly for the interior surfaces of concretes, plasters.
It is also recommended for the wooden and metallic surfaces. It provides excellent chemical and
weather resistance to the substrates, good abrasion and impact resistance and alkali resistance .
|
Color |
White or any requested colors. |
|
Finish |
Glossy |
|
Density (gm/cc) |
1.15 |
|
Volume Solids % |
38% |
|
Theoretical Spreading Rat |
12 sq. mt/ lt at 30 micron DFT(depends upon the substrate condition & method of application) |
|
Washability |
N/A |
|
Overcoat Interval |
6 hours |
|
Flash Point |
28 degrees cel. |
|
Mixing Ratio |
2:1 - Base : Hardener ( v/v ) |
|
Pot Life |
3 hours |
|
Gallon Size |
15 Liters |
Storage
The product must be stored in accordance with national regulations.The product must be kept in a cool and well-ventilated place ,protected from heat and direct sunlight.
Surface Preparation
Should be stable , firm, dry and free from laitance,dust and loose flaking materials,loose old paints, dirt, grease, wax and any other contaminations.
Application Details
|
Range |
Typical |
Max |
Min |
|
Wet Film Thickness (micron) |
79 |
105 |
79 |
|
Dry Film Thickness (micron) |
30 |
40 |
30 |
|
Temperature |
15oC |
25oC |
40oC |
|
Drying Time (S/D) |
3 hours |
1 hour |
30 minutes |
|
Dry Time (H/D) |
18 hours |
6 hours |
3 hours |
Application Guidelines
|
|
Air spray / Airless spray |
Brush/Roller |
|
Type of Thinner |
Rose PU Thinner |
Rose PU Thinner |
|
Volume of Thinner |
0 – 5% 15 – 20% |
10 – 15% |
|
Nozzle Orifice |
0.022 1.0-1.5mm |
- |
|
Nozzle Pressure |
2100 psi 2 – 3 bar |
- |
Paint System Advice
• 1 coat of epoxy primer ( RS-5770 ) can be applied before the filler coat.
• An epoxy filler ( RS-5780) coat can be applied for the wooden and cementous
surfaces . Normally no filler coat is applied on the metal surfaces unless the
surface is very uneven.
• 1-2 coats of Rose Polyurethane Gloss (RS-5640) can be applied over the primer
coat or over the putty coat depending upon the substrate natures.
Safety Precaution
• Avoid contact with eyes and prolonged contact with skin.
• Keep containers tightly closed when not in use .
